The Seagull Century is held each October in Salisbury, MD and was my introduction to century rides. I traveled with a group of friends from Pittsburgh for several years in a row before I moved to Columbus. The route is very flat because it is on the MD peninsula and it is a great ride because the weather is usually pretty warm, although rainy and at that point in the season a flat century is relatively easy. The 60 mile stop is on Assateague Island where the wild horses run free. Scroll down a little to see a couple years worth of my photos. I was 25lbs heavier which I have since lost from cycling.
Nearly 30 years ago, J. David Rhoades had a unique idea – to design and market a 4-wheel bicycle that everyone could enjoy. He appropriately named it the Rhoades Car... http://www.rhoadescar.com/rcar/index.shtml
The simple tension seeker (STS) by DMR Bikes should not really be called a chain tensioner , but rather a slack-remover. It's an incredibly simple solution for those looking to convert a bike with vertical dropouts for single speed use. DMR is a UK-based company that specializes in downhill, freeride, and dirt jump chain devices, and the STS reflects this design experience in this burly device. Installation is a 5-minute job (assuming you have already replaced your cassette with a cog, and shortened your chain as much as possible). Simply remove the skewer nut and slide the black aluminum mounting bracket onto the dropout. Then loosely bolt the stainless steel arm to the bracket and the derailleur hanger with two 5mm bolts. Replace the skewer nut. Rotate the cranks until the chain is at its tightest. (Very few chainrings and cogs are perfectly round.) Lift up on the arm so that the red pulley pushes the chain upward, removing the slack, and tighten the two 5mm bolts. That...
Comments
Post a Comment