A High-Tech Rickshaw For The 21st-Century Commuter
Get link
Facebook
X
Pinterest
Email
Other Apps
By
Bill
-
INTRODUCING ECLIPSE: A PRETTY REDESIGN OF THE CENTURIES-OLD STREET VEHICLE.
Rickshaws, perhaps better known now as pedicabs, have come into vogue in recent years as a greener and easier alternative for getting around in crowded American cities. Next week in particular, thousands of visitors will swarm Austin, Texas, for the annual South by Southwest festival, and will likely rely on some 500 or more pedicabbies for transportation between events.
That said, none of those carriages are likely to be as stunning as Eclipse, a new rickshaw concept that its designer Kenneth Cobonpue calls “a more civilized version of the humble three-wheeler.”
In both the United States and in South America and Asia (where Cobonpue’s studio is headquartered) modern rickshaw designs haven’t evolved much past their original 1800s counterparts--and in some ways, that’s okay. Passenger carts are low-tech by definition: they operate off the grid and are used exclusively for short distance travel. At the same time, if rickshaws came with a few more amenities, perhaps their adoption rate would imprive in urban areas.
Cobonpue’s proposal includes things that passengers might find on an Amtrak or in a new car: cupholders, an iPhone charging dock, speakers, a fan, and panels that can close. The feel of luxury is meant to extend to the peddler, too: the handlebars and seats are covered in soft, but waterproof, hand-stitched faux leather. The entire vehicle is built from aluminum and a woven polyethylene, so it’s both sturdy and lightweight. The piece is in line with Cobonpue's other work, which features woven, hardy, outdoor furniture.
Nearly 30 years ago, J. David Rhoades had a unique idea – to design and market a 4-wheel bicycle that everyone could enjoy. He appropriately named it the Rhoades Car... http://www.rhoadescar.com/rcar/index.shtml
The simple tension seeker (STS) by DMR Bikes should not really be called a chain tensioner , but rather a slack-remover. It's an incredibly simple solution for those looking to convert a bike with vertical dropouts for single speed use. DMR is a UK-based company that specializes in downhill, freeride, and dirt jump chain devices, and the STS reflects this design experience in this burly device. Installation is a 5-minute job (assuming you have already replaced your cassette with a cog, and shortened your chain as much as possible). Simply remove the skewer nut and slide the black aluminum mounting bracket onto the dropout. Then loosely bolt the stainless steel arm to the bracket and the derailleur hanger with two 5mm bolts. Replace the skewer nut. Rotate the cranks until the chain is at its tightest. (Very few chainrings and cogs are perfectly round.) Lift up on the arm so that the red pulley pushes the chain upward, removing the slack, and tighten the two 5mm bolts. That...
Comments
Post a Comment