These Powerful LED Bike Lights Make Cyclists As Bright As Cars | FastCompany
Get link
Facebook
X
Pinterest
Email
Other Apps
By
Bill
-
Cars have no excuse to not see a cyclist with these lights, which are as bright as a car's and shine out in every direction.
After a couple of years of riding his bike home after work in Seattle's dark, rainy weather, engineer Pete Clyde started to drive more often. As a cyclist, he realized he just wasn't visible enough at night, even with the brightest bike lights. So Clyde designed a light of his own.
The new LED lights, called Orfos Flares, make a bicycle as bright as the cars around it. "As I rode at night, I realized that cars normally scan for other cars," Clyde says. "If you think about what a car looks like from the side, you can see it from many angles. Bikes don't have that. By designing bike lights with 360 degree visibility, you get that same aspect of the wraparound objects."
The lights use ultra-efficient LEDs glowing at 500 lumens, the same brightness as taillights on a modern car. A clear silicone shell lets the beam shine out in every direction, surrounding the cyclist with a circle of light. The lights are bright enough to be used even in the daytime. Unlike car lights, they can also flash, to make it clear to drivers that you're on a bike.
In the past, the lights wouldn't have been possible to make. "When LEDs first came out, they weren't efficient enough to provide a wide beam with a portable battery source," Clyde explains. "With the newest LED technology, you can get a lot more light out, and it will be bright from any angle."
Extra-bright bike lights aren't new, but others haven't worked well. "A lot of the cheaper products don't have as much power, and they're not as efficient," says Clyde. "They focus all the way straight back or straight forward, and what ends up happening is you blind the driver if they get stuck in that beam—and no one else sees it outside of that beam. Modern LED technology is now going to allow for better visibility."
The lights, which can be attached to a bike frame, helmet, or backpack, aren't cheap. On Kickstarter, where they're currently crowdfunding, a single light is...
Nearly 30 years ago, J. David Rhoades had a unique idea – to design and market a 4-wheel bicycle that everyone could enjoy. He appropriately named it the Rhoades Car... http://www.rhoadescar.com/rcar/index.shtml
The simple tension seeker (STS) by DMR Bikes should not really be called a chain tensioner , but rather a slack-remover. It's an incredibly simple solution for those looking to convert a bike with vertical dropouts for single speed use. DMR is a UK-based company that specializes in downhill, freeride, and dirt jump chain devices, and the STS reflects this design experience in this burly device. Installation is a 5-minute job (assuming you have already replaced your cassette with a cog, and shortened your chain as much as possible). Simply remove the skewer nut and slide the black aluminum mounting bracket onto the dropout. Then loosely bolt the stainless steel arm to the bracket and the derailleur hanger with two 5mm bolts. Replace the skewer nut. Rotate the cranks until the chain is at its tightest. (Very few chainrings and cogs are perfectly round.) Lift up on the arm so that the red pulley pushes the chain upward, removing the slack, and tighten the two 5mm bolts. That...
Comments
Post a Comment