Mad River Ride June 20, 2010

By -
Highlights
Covered Bridge Tour
25+ riders at start
Nice little climb from the valley and a nice downhill (I hit 38mph)
After the rest stop I rode with the 9 riders on the longer, hillier route back
Total 35 miles
Averaged 16.5mph
Climbed 1250 feet


Comments

Post a Comment

Popular posts from this blog

Product Review: Convert your geared bike to singlespeed (DMR STS chain tensioner)

By -
Image
The simple tension seeker (STS) by DMR Bikes should not really be called a chain tensioner , but rather a slack-remover. It's an incredibly simple solution for those looking to convert a bike with vertical dropouts for single speed use. DMR is a UK-based company that specializes in downhill, freeride, and dirt jump chain devices, and the STS reflects this design experience in this burly device. Installation is a 5-minute job (assuming you have already replaced your cassette with a cog, and shortened your chain as much as possible). Simply remove the skewer nut and slide the black aluminum mounting bracket onto the dropout. Then loosely bolt the stainless steel arm to the bracket and the derailleur hanger with two 5mm bolts. Replace the skewer nut. Rotate the cranks until the chain is at its tightest. (Very few chainrings and cogs are perfectly round.) Lift up on the arm so that the red pulley pushes the chain upward, removing the slack, and tighten the two 5mm bolts. That...
Read more