REED cycles

By -

SFP ($4,300)
OX Platinum Frame with 44mm headtube top and bottom – Paragon Dropouts / Belt Drive Compatible
American Classic All-Mountain 29 Tubeless Wheelset
Tapered Fox 29 32RLC Fork – 15mm Axle
Formula – The One DH brakes
Thompson Seatpost and Stem
Gates Carbon Drive (Center Track) Single Speed System (46 x 28) - single speed
TruVativ Stylo Crank and Carbon Handlebar
WTB Saddle
Kenda Nevegal Tires 2.35"
PFP ($3,700)
OX Platinum Frame with 44mm headtube top and bottom – Paragon Dropouts / Belt Drive Compatible
American Classic All-Mountain 29 Tubeless Wheelset
RockShox Reba RLT Dual Air 100mm, QR.
Avid Elixer 5 Brakes
TruVativ Stylo Seatpost, bar & Stem
Gates Carbon Drive (Center Track) Single Speed System (46 x 28) - single speed
Kenda Nevegal Tires 2.35"
REEB Frame + Belt Drive Combo (1,650)
REEB Frame Only (1,400)

[REEB]

Comments

Post a Comment

Popular posts from this blog

Product Review: Convert your geared bike to singlespeed (DMR STS chain tensioner)

By -
Image
The simple tension seeker (STS) by DMR Bikes should not really be called a chain tensioner , but rather a slack-remover. It's an incredibly simple solution for those looking to convert a bike with vertical dropouts for single speed use. DMR is a UK-based company that specializes in downhill, freeride, and dirt jump chain devices, and the STS reflects this design experience in this burly device. Installation is a 5-minute job (assuming you have already replaced your cassette with a cog, and shortened your chain as much as possible). Simply remove the skewer nut and slide the black aluminum mounting bracket onto the dropout. Then loosely bolt the stainless steel arm to the bracket and the derailleur hanger with two 5mm bolts. Replace the skewer nut. Rotate the cranks until the chain is at its tightest. (Very few chainrings and cogs are perfectly round.) Lift up on the arm so that the red pulley pushes the chain upward, removing the slack, and tighten the two 5mm bolts. That...
Read more